Montini Nymph and and old Satyr Wall Set (Lego Compatible)
Montini Nymph and and old Satyr Wall Set (Lego Compatible)
3D
Published 2020-02-16T20:15:21+00:00 • Remixed from Montini building bricks Two Pip Set (Lego Compatible), Montini building bricks Female Plate Set (Lego Compatible), Montini building bricks Pip Strip Set (Lego Compatible), Montini building bricks One Pip Set (Lego Compatible), Nymph and and old Satyr
This set of Montini bricks forms a relief which depicts a nymph and an old satyr, a common scene in Greek mythology.
Just like the vintage original Montini parts, these are compatible with classic Lego full height bricks.
Montini building bricks were produced from 1961 to 1969 in the Netherlands. They were originally made from soft, pliable polypropylene. The diagonal fins bend slightly around the pips of the other block.
puppenhausmuseum.de/montini-bausteine.html
Please do not mix these with original Montini parts. PLA is much harder than the original bricks, and the layer ridges act like sand paper. You will wear out the original Montini bricks very quickly.
I would love to see your make!
Original art scan by Scan The World:
www.myminifactory.com/object/3d-print-nymph-and-and-old-satyr-78336
These are optimized for a 0.4mm nozzle. They are friction fit parts, so tolerances are important.
I set the Horizontal Shells Top to 7, and Bottom to 10 to allow for the relief to have infill, but the brick to be solid.
The following parts need supports on the relief section. The bricks themselves do not need supports:
1_6_NymphAndAnOldSatyr.stl
1_7_NymphAndAnOldSatyr.stl
| 发表的日期 | 16/02/2020 |