Mountain Bike Brake Line Bung
Mountain Bike Brake Line Bung
3D
Published 2020-04-10T22:40:12+00:00
I upgraded my mountain bike from cable brakes to hydrolic brakes and this bung replaces the one that held the rear brake cable. I needed to make this in order to hold the cable in place under the top tube as it runs up to the headset.
I'm not sure how many bikes these exact dimensions would apply to, but mine is a trek hardtail. It's an easy print and worth a try for people making this upgrade. A ziptie would work but this is sexier.
I printed it out of PLA, probably should be something tougher but it's been working fine. I also printed it with pretty obnoxious wall layers and infill, it's small enought that it doesn't really make a difference. I also printed with a small layer hieght to make the taper as smooth as possible.
Layer height: 0.08 mm
Perimeter Shells: 3
Bottom Solid Layers: 6
Infill: 30%
Print Speed: 50mm/s
Travel Speed: 70mm/s
Temperature: 230 degrees C
| 发表的日期 | 10/04/2020 |
| 材料数量 | .35g |
| 尺寸大小 | 10mm x 10mm x 20mm |
| 支持自定义 | YES |
