Nature Clamp - Mokacam Contest
Nature Clamp - Mokacam Contest
3D
Published 2017-04-18T13:51:00+00:00
________________________________________________
This is a Nature Grip. It's purpose is to be able to film from every angles in a forest.
When there is a tree nearby, just open the device and put it on any tree trunks or branches (slim or thick).
Also, you can take it with you in your hand with it's handles made to fit your hand. The grip is small and doesn't take any space in a backpack.
The Nature Grip is designed with 3 axis so it has the ability to capture every angles in a forest or in a saktepark, anywhere there is a pole aviable.
A bolt at the top of the grip makes it easy to set up the camera on it.
It is easy to set up, simply find a branch, use the rubber band to tighten it in place, then find the angle you want and screw it in place. Fixing in place the camera in the right angle is easy with one of it's screws that locks in 2 axis at the same time.
________________________________________________
Due to time restraints, i couldn't get any HEX bolts and butterfly fastener. Those are necessary to make the product work as intended.
M4-25mm bolt/nut were used
________________________________________________
I want to thank Mokacam and MyLittleFactory to make these incredible contests
Émile Santerre
| 发表的日期 | 18/04/2017 |
| 让时间去下载 | - 180 分钟 |
| 材料数量 | 46g |
| 尺寸大小 | 170x35x18mm |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |