Nerf technical(RC controlled)
Nerf technical(RC controlled)
3D
Published 2016-09-27T11:22:01+00:00
Roughly a week of development for this one and probably around 6 less successful prints, this is what came of it!
You hook it up to a receiver and use it as a standalone turret och put it on a RC vehicle. I hotglued it to the flatbed of my 3D printed RC truck V3, quite fun!
As usual I went wild with hardware ... You need these:
2x M3 rods x 40mm
2x m3 rods x 75mm
6x M4x10
19x m3x10
10x m3x16
3x standard size servos
2x 6700zz bearings
Couple of rubberbands or springs
You can find videos about this project and others at my youtube channel:https://www.youtube.com/mrcrankyfaceprojects
Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface
Patreon: http://patreon.com/Mrcrankyface
| 发表的日期 | 27/09/2016 |
| 让时间去下载 | - 550 分钟 |
| 材料数量 | 155g |
| 尺寸大小 | 130x208x70 |
| 打印工艺 | FDM |
| 支持自定义 | YES |
