Nut Cracker
Nut Cracker
Published 2020-11-23T11:20:20+00:00 • Remixed from Falcon Clamp (quick print), Falcon Clamp
Experimental Nut Cracker. Didn't fare so well against the mighty Macadamia but still shows promise. Pictured with aluminium reinforced jaws, though on its own has a hard bite. Gear ratio 1:41.667.
Prints in place fully assembled without supports.
IMPORTANT: Print at 0.2mm layer height if using the default model, otherwise ensure layer_h parameter matches your layer height if customizing. Check preview before printing and ensure the 1-layer gap is preserved in the outer ring gears.
Use a sharpened spatula, single-edged razor or similar to de-laminate the 1-layer gaps (watch fingers and listen for the "crack"), then turn the knob just a little to get the gears moving. Now "crack" the jaws apart manually by back-driving by a few mm (there should be a little backlash). Now all the parts are free, it will be a bit stiff at first but opening and closing a few times will loosen it up. Then apply petroleum jelly or lubricant of choice to gears and work it in (again by opening and closing a few times). Optionally reinforce jaws with aluminium angle or stainless steel and a bit of glue.
发表的日期 | 23/11/2020 |
支持自定义 | YES |