PETlock no drift bed adjuster thumbwheel, easy grip
PETlock no drift bed adjuster thumbwheel, easy grip
Published 2020-11-24T11:45:17+00:00
A non-drifting adjuster for setting the bed leveling on FDM printers. Works on the same principle as a Nylock nut. Printable in PET, ABS or nylon (it may also work with PL, but I don't guarantee that as I haven't tried it!)
Assembly & Use:
1) Place an M3 nut on a hard surface, align the points of the thumbwheel with the points of the nut and press the thumbwheel onto the nut
2) Turn the thumbwheel over. Lightly screw an 8mm (or longer) M3 screw into the nut, then keeping downward pressure on the screw, screw it in to form an inner thread in the plastic.
3) Replace the standard (non-locking) bed adjusters on the printer re-level the bed and forget about needing to do it again for a long time!
Print at any convenient layer height.
Print using PET (PET-G etc.), ABS or nylon.
| 发表的日期 | 24/11/2020 |
| 尺寸大小 | 0mm x 0mm x 0mm |
| 支持自定义 | YES |