phone / tablet holder / stand by Kelmannen
phone / tablet holder / stand by Kelmannen
3D
Published 2017-11-13T10:56:19+00:00
A very simple and fast stand with a 4mm screwhole on the backside, i searched for it on MMF and thingiverse but couldn't find any so i made this myself instead!
the support "slot" is 29x10mm with a 2mm lip and 4mm screwhole, the total size 25x30x10 so actually it stand really good without screwing it down!
it has a left/right part but the only difference is on which side the back support is, otherwise it's the same model!
as seen on the pictures you can print it both lying down and standing up, i would recommend lying down because that one feels a lot stronger when i stress them.
no support, print it lying down for the stiffest backrest, almost at whatever speed you want.
| 发表的日期 | 13/11/2017 |
| 让时间去下载 | 10 - 15 分钟 |
| 材料数量 | 1g |
| 尺寸大小 | 25x30x10 |
| 支持自定义 | YES |