Pocket Door Hanger / Hinge
3,699
views
85
downloads
0 comments
Loading comments...
Pocket Door Hanger / Hinge
3D
Published 2015-06-16T11:48:51+00:00
12
0
Add to Collection
Description
This is a replacement part for a pocket door. It screws into the top of the door and provides the bearing surface for the door to slide on it's rails. It is designed to be printed in PLA, investment cast, and then threaded. The thread pitch for the original part that was duplicated was 5/16-32, so was too fine to print or cast successfully.
In the picture, the original die cast piece is on the left and three replacement parts that were printed in PLA and then cast in brass are shown on the right.
Printing Details
Print at 0.2 mm layer height, with 10% infill. This uses 1 g of filament and takes 5 minutes.
Technical Information
发表的日期 | 16/06/2015 |
让时间去下载 | 5 - 10 分钟 |
材料数量 | 1 g |
尺寸大小 | 13 x 40 x 13 |
复杂程度 | 非常容易 |
More Information
Object Parts