Rubber band power boat
Rubber band power boat
3D
Published 2018-07-10T17:16:54+00:00
This is a fun boat to play with using rubber bands to make it move. To set it up you will need a hot glue gun and all the 3d prints with the spikes coming out of the separate hook. Make sure the raft is off. You will need to put the pole that the propeller is connected to through the hole at the back of the boat. Hot glue the separate hook on to the opposite side of the pole to the propeller. Then get a small rubber band and depending on the size of the boat printed, you may need to double the rubber band in the hooks. Twist the propeller 15-20 times then put it in water.
Print it smaller if you do not have a good quality printer or you can print it larger if you have a good printer. If your printer can not handle overhangs print with supports and make sure you get all the raft and supports (if you have any) off. Make sure you don't cut the small bits off, it would be best to refer to the model to know that what you are cutting it correct.
| 发表的日期 | 10/07/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |