1) Stick the magnet to the bottom of the Ramsta to find out which way the internal magnet is polarised. 2) Turn the magnet over and superglue it into the baseplate so that pole faces upwards (so the magnet will attach itself to the Ramsta and hold the plate in place). Keep it WELL away from any electronic equipment as neodymium magnets are very strong and won't do your iPhone any favours at all. 3) Place the Ramsta onto the baseplate and put one half of the base around it. Do NOT glue it in place or you'll never be able to change the batteries when they die. 4) Slot the lamp into place. This you can glue if you want. I didn't on the prototype model but there's no reason it couldn't be done. 5) Superglue the side faces of the other half of the base, making sure not to get any glue on the bottom or in the curved half-hole where the lamp sits. 6) Slot the glued half into the base plate, bringing the two halves together, and huff on it until they stick solidly. Your Push Light is now ready to use!
Print at 0.2 mm layer height, with 10% infill.