Please enter the code below
This is a 4 piece set of labyrith figurines that have a robot theme.
2 of the figures are slightly taller like the original pieces. (picture of them in box included)
They have a base of 1cm diameter.
My test prints were done with no supports.
I have included 2 individual photos of each figure, 1 software image, 1 image of the figures in the game box and 1 image of them on a game piece.
No supports necessary. (minimal overhangs and most overhangs are a steep gradient)
I used 0.1 mm layer height and between 25 and 30 % infill.
Took me about 30 minutes per figure at about 40mm/s
Layer height can be increased to 0.2mm to print quicker.