Roll Support for Spools - Ender 3 - V2
Roll Support for Spools - Ender 3 - V2
Published 2019-11-17T20:10:13+00:00
Version 2 (V2)
I made a smaller version, so now it fits smaller spool holder holes.
It fits as low as a internal spool holder diameter of 56mm
If you like my designs, please support by tipping me. Even $1 is fine :) https://paypal.me/bmabma
----------------------------------
The original spool holder of Creality Ender 3 has a diameter (30mm) too small in comparison to the spools i've been using (74mm) so I did this support.
There are 2 supports that are clamped to the original spool holder, and each one has 2 rolls on the top that make contact with the spool. No need to use bearings, bolts nor any extra part, just print it!
I used 0.2mm of layer height, 0.20 infill and tree supports
You need to print:
- 2x Roll support for spools - Ender 3 - CLAMP
- 4x Roll support for spools - Ender 3 - ROLL
- 0.2mm of layer height
- 0.20 infill (or more)
- support for both models
- axis of clamp / roll aligned with Z (vertical)
发表的日期 | 17/11/2019 |
材料数量 | 60g |