Rubber Band-Powered Flying Bat
Rubber Band-Powered Flying Bat
3D
Published 2017-10-11T09:51:56+00:00
This object was made in Tinkercad. https://www.tinkercad.com/things/cCE45uUnaJx
This is a rubber band-powered flying toy to surprise your friends when it flies out of a letter, book, card, magazine, etc. It was also designed to fit the 30mm long rubber band. The total weight is under 1 gram. This is a subgram plane.
I designed a flying butterfly and a dragonfly. For more information, see the butterfly and dragonfly toys.
You will need materials and tools as follows
. Rubber Bands : 30mm long (lay flat length) and 1.4mm thick
. Aluminum(coke or beer) can, and scissors
. 1.5mm drill bit and hand chuck
. A small file or sandpapers
. Some Super Glue (CA)
How to take flight : Wind the upper wings 30~40 times.
. Let go, it will fly up. Or,
. Place in a card , a book or under an object. When released, it will fly
. No support, no raft.
. Resolution:0.2mm layer thickness
. Infill:100%
| 发表的日期 | 11/10/2017 |
| 让时间去下载 | 8 - 9 分钟 |
| 材料数量 | about 980 mg |
| 尺寸大小 | 64mm*72mm*2.7mm |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
