Springo Skull
by MakeAnything
Springo Skull
Featured
26,178
views
6,190
downloads
14
collections
Add to collection
389
44
44 comments
Loading comments... 
Springo Skull
Published 2017-05-17T07:18:37+00:00
OR
Save for later
Description
What a spooky Springo!
Print at .15mm layer height and separate spring manually after printing, no supports required.
Printing Details
100% infill is recommended. Results vary by slicer, but basically make sure the layers above and below the small Springo gaps are printing solid. Simplify3D recognizes these as top and bottom layers so you can use a lower infill, but Cura won't recognize the layers as top/bottom, and therefor prints infill instead of solid.
Technical Information
| 发表的日期 | 17/05/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 非常容易 |
| 支持自定义 | YES |
Object Parts
|
I printed it in this in PLA from Cura on my Printrbot Metal Plus. Cura crashed and lost my settings, so I'm trying my best to remember, but I think I used a .15mm layer height 15% (could have been 25%) infill, 3 top and bottom layers, I used a box cutter inserted it into one of the slits and gradually turned the part pushing the part into the blade, not the blade into the part. I cam apart easier than I thought, but it still takes some time. I probably took me 5-10 mins to split mine apart. Otherwise, it looks great. I'll be bringing this to the STEAM Maker Fest in San Diego this summer. I think kids it'll get a kick out of it. Thanks Devin!