Soft Fabric Sewing Tape Measure Case
Soft Fabric Sewing Tape Measure Case
3D
Published 2020-07-29T12:32:14+00:00
A simple case to hold your fabric tape measure.
To put together:
Insert the metal end (from the highest number side of the tape) into the center slot.
Use a little smear of dish soap or wax on the sphere located on the peg of the lid component.
Thread the tape through the slit in the base and align the pin on the lid to the center hole on the base
Place the combined unit on a table and using you palm, snap the two components together
Print Settings
Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.20
Infill:
15%
Filament_brand:
Hatchbox
Filament_color:
Orange
Filament_material:
PLA
Notes:
PLA Extruder = 205 Bed = 60 Stock magnetic build plate.
Should fit tapes up to 16.5mm (5/8in) wide and 1524mm (60in) long.
If the components are too tight to snap together you are likely over extruding. If the components are too loose you are likely under extruding. To fix this google e-step and flow calibration.
Designed in fusion 360 and sliced with Cura
| 发表的日期 | 29/07/2020 |
| 支持自定义 | YES |