!Note!

• This project has not been test-printed by me
• So certain parts might need to be scaled accordingly in order to fit
• Drop me a feedback in the comment section
• Post your make!
• To be updated once it has been test-printed by anyone!

Instruction:

• Use Body.stl or combination of Body1.stl and Body2.stl
• The Strap should just slide into the left leg of Staryu
• Refer to picture no.3 for the placement of the stand

I designed with part separation in mind so that it is easier to clean up, especially when you plan to sand and paint it. I have also included a whole Staryu model if you print that instead.

Check out my sites here!
Support me here! https://www.buymeacoffee.com/jettohobby
Facebook: https://www.facebook.com/Jettohobby/
Instagram: https://www.instagram.com/jettohobby/
YouTube: https://www.youtube.com/channel/UCGyG-xNly4YAg6kF_9Pojdg
Etsy: https://www.etsy.com/ie/shop/JettoHobby

TOOLS TO HELP YOU GET STARTED:

3D PRINTERS:
https://amzn.to/2Q1nLIk (What I use)
https://amzn.to/2Q37DWI (What I use)
https://amzn.to/2DQHN6b (Recommend)
https://amzn.to/3kRKt3Q (Recommend)
eSun PLA+: https://amzn.to/2Yco47U

AIRBRUSH SET:
Airbrush that I use: https://amzn.to/342CGKK
Airbrush + Compressor: https://amzn.to/2CCUeSq
Vallejo Airbrush Cleaner: https://amzn.to/2YpHciX
Vallejo Model Air Set: https://amzn.to/348Xgcw
Vallejo Airbrush Thinner: https://amzn.to/3iSwYiN
Vallejo Gloss Varnish Metal: https://amzn.to/3kPOkhX

OTHER TOOLS:
Sandpaper Set: https://amzn.to/3g62O9Z
Pre-soldered Micro LED: https://amzn.to/3iPvSUY
Adjustable Soldering Iron Kit: https://amzn.to/2Y87SV4
Hobby knife: https://amzn.to/3g8T2DL
Tamiya scriber II: https://amzn.to/2CCRZP0
Gorilla Super Glue XL: https://amzn.to/31XlP9n
Lacquer thinner: https://amzn.to/3kRJD7o