Vertical Cable Chain for Geeetech A10
Vertical Cable Chain for Geeetech A10
3D
Published 2020-01-06T11:36:22+00:00
This is an Vertical Cable Chain for Geeetech A10 Printer.
It's a remix of "ENDER 3 - Convoyeur vertical de câbles / vertical cable chain" (https://www.thingiverse.com/thing:3392557).
Print Settings
n x BARRETTE : Layer:0.15mm Raft:no Support:no Infill:100%
n x MAILLON : Layer:0.15mm Raft:no Support:no Infill:100
1 x MAILLON_DEPART_Z : Layer:0.15mm Raft:no Support:yes Infill:100%
1 x MAILLON_FIN_Z1: Layer:0.15mm Raft:no Support:yes Infill:100%
1 x MAILLON_FIN_Z2: Layer:0.15mm Raft:no Support:yes Infill:100%
1 x PLATINE_EXTRUD_REMIX : Layer:0.15mm Raft:no Support:yes Infill:100%
Accessories
3 x rislan
2 x m3x12mm SHCS
2 x m3 jam nut
2 x m3 washer
Mounting
The MAILLON_DEPART_Z is inserted on the top of the left rear ail.
The PLATINE_EXTRUD_REMIX is fixed with m3 screws, m3 washers and m3 jam nuts on the platine of extruder ; two holes already exist on the platine.
Keep MAILLON_FIN_Z1 and MAILLON_FIN_Z2 around electrical wires with a rislan (look at pictures).
| 发表的日期 | 06/01/2020 |