This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
This pistol goes perfectly with any Imperial Warhammer 40K cosplay, prints easily without any supports, is fun to paint and has a suprisingly nice balance when handled.
The way it was split ensures it will fit on any regular desktop printer and in addition makes clean painting as easy as possible.
print at 0.1 - 0.2mm layers (I printed everything at 0.15mm) 3-4 perimeters 30% infill no supports needed * Grip: You can either print "grip_full.stl" vertically (will require minimal supports) or print the two grip halves ("grip_1.stl" & "grip_2.stl") and put them together with the dowels and some glue. BOM (Bill of Materials):
Any glue that fits your chosen material (Superglue and/or 5-minute epoxy for PLA; Acetone for ABS) 4x short countersunk M4 screws for the handle (decorative purpose only). Alternatively you could use tape or straps of cloth for a more post-apocalyptic look. spray paint, acrylic/oil paints, etc.