WiFi signal booster
WiFi signal booster
3D
Published 2018-02-14T18:21:12+00:00
That is my FREE WiFi signal booster. Nowadays we have in our homes WiFi transmitters but usually, in the room, you are chilling in the signal is the worst. Print this two parts that are extremely easy to print and cut your empty RedBull (or similar) can. That antenna combines the strengths of the complicated part that are 3d printed with the recycling of cans and the aluminum property to deflect radio waves.
It is very useful also for radio controlled drones since it improves the range of the drone up to 10 times. The principle of the antenna deflector is very simple. Deflector deflects the waves easily to existing antenna that collect more radio waves from longer distances for the price of the smaller receiving angle.
Please try it out. If you have any problems I am here to change the STLs. I will also post the Fusion 360 files so you can make my project better!
Printed well in PLA at .2mm layer height with 20% infill and no supports. Rotate each part 90˚ around X axis to lay flat on build plate.
| 发表的日期 | 14/02/2018 |
| 让时间去下载 | 50 - 100 分钟 |
| 材料数量 | 24g (total) |
| 尺寸大小 | 143mm x 53mm x 7mm (each) |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |