Yin Yang Cat Fridge Magnet & Ornament / IEC3D
Yin Yang Cat Fridge Magnet & Ornament / IEC3D
3D
Published 2018-12-15T21:12:12+00:00
This Yin Yang Cat fridge magnet and ornament uses a 10mm x 3mm magnet that we purchased from Amazon in a pack of 100 for about $10. The magnet can be glued inside the hole in the back with super glue or Goop that we purchased at Home Depot. We also added 4 ornament hooks so you can hang on your Christmas tree or wall. We included small, medium and large sizes of the standard cat, a thinner version and also included a cat with lower level whiskers and another with no whiskers or eyes (a true yin yang design). The cat with the whiskers can be difficult to print cleanly, and the whiskers can get knocked off if cleaning is required (although we added a support to tie them together and make them stronger). The thin version may actual look the best because you change the filament after just 2 mm height. On all other versions we were able to locate the magnet in the center of the design (instead of at the top) so it can be rotated in any position while on your fridge. Enjoy and Merry Christmas from the IEC3dDesignWorks team.
OK to print at .20 resolution at 10% infill. We use Elmers glue stick on blue tape and then add a touch of hairspray (if warping is an issue) and mix the slurry together until white and tacky (no longer wet and slippery). This reduces any warping and curling on the edges of medium to large size base models, or on prints longer than 150 mm. Change the filament to the color of your choice after you see the printing is above the ornament hook level. We designed that thickness as a filament change "indicator". Happy printing from the IEC3dDesignWorks team.
| 发表的日期 | 15/12/2018 |
| 让时间去下载 | 20 - 160 分钟 |
| 支持自定义 | YES |