Finished 200% Scale ABS 22.5Inches tall Eva Unit 01. Needs a lot of clean up then acetone wash to remove all the scaling and some cracks to fill. But Here he is in all his glory. Printed on a CR-10 this is almost as big as I could make it without cutting it up into parts. Used around 2.5KG of filament and took about 250 hours total 100 hours being the torso and around 20-40 for each limb 18 for the head. Most of the body was printed at 100-200 microns depending on the part legs where printed at a lower res for strength and time.