Adafruit MicroLiPo Charger Enclosure
Adafruit MicroLiPo Charger Enclosure
3D
Published 2020-02-03T19:33:42+00:00
I know these little chargers are used in projects, but sometimes you just want a little dedicated LiPo battery charger. Since I'm cautious about exposed electronics, (regardless of the current and voltage) I designed a tiny enclosure for this board, to be used as a standalone battery charger.
The enclosure is 100% 3D printed; no screws or adhesives are necessary to keep the enclosure casing halves together. Simply place the PCB in the correct orientation, and snap the top casing to the bottom.
There is a split viewing port on top of the case for the LED indicators to be seen through, as well a a port on the bottom... to see the Adafruit flower logo. :D
(Piss off I like the logo.)
Standard Print Settings:
Extruder: 212C
Bed: 56C
First Layer Print Height: .30mm
Wall Thickness: .40
Wall Perimeters: 2
| Date published | 03/02/2020 |
| Support Free | YES |