Alpha 3D Model Rocket
Alpha 3D Model Rocket
Published 2018-04-03T12:01:12+00:00
This is my tribute to a classic Estes kit. The Estes Alpha III was one of the first rocket kits I built as a kid. While this isn't an exact copy of that kit, it is quite similar appearance.
You can either print just the nose cone and fin canister and use standard BT-50 body tube (6" long) or you can print the body tube model using 'vase mode' (single wall spiral w/ no top or bottom).
You can use either ABS or PETG for printing. I used ESun PETG translucent orange for my 'full print' version. For ABS I've found the FoxSmart ABS to be a good and cost effective filament. The version built with a standard body tube has red FoxSmart ABS for nose cone and fin canister. The 'thick' version of the fin canister has slightly thicker fins for more durability.
Try an A8-3 for first flight, B6-4 for second flight.
Launch video: https://youtu.be/lyxZVnFooGs
0.2mm layers, 2 perimeters, 50% infill. Always print fins up.
Tie 36" (1m) shock cord to fin canister, thread through body tube, tie to nose cone. Add streamer. I use mylar gift wrap, but you can also use a strip of a trash bag.
Date published | 03/04/2018 |