Bath/Sink Plug
Bath/Sink Plug
3D
Published 2020-09-25T15:55:22+00:00
I had a poor fitting metal plug in my bath which has annoyed me for quite a while due to the not-quite-right fit so I have created a plastic version.
This is a two part design so that it can be printed without supports or the need for any bridging. Initially, the idea was to glue the two parts together but I found that, once printed, the two parts snap together with a satisfying click. This will depend on the printer calibration.
The plug does not have a handle and is to be used with a chain fitted. The bath plug has a maximum diameter of 44 mm and the sink plug is 37.4 mm.
Update
On the bath plug, the plastic section which is attached to the chain broke so I have modified the bath plug attachment to be a little meatier. A combination of the weight of water and the amount of suction from removing the plug from the hole requires quite a lot of force to release the plug. Please use version 2.
Printer: Ender 3
Resolution: 0.20 mm
Speed 50mm/s
Material: PETG
Nozzle Temp: 240°
Bed Temp: 70°
Infill: 20%
Walls: 3
Top Layers: 4
Bottom Layers: 4
| Date published | 25/09/2020 |
| Benoetigte Zeit | 42 - 60 Minuten |
| Menge an Filament | 9.68 grams |
| Dimensionen | 44 x 44 x 10 mm |
| Support Free | YES |