Coffee Machine using 250mL can
Coffee Machine using 250mL can
3D
Published 2018-02-19T10:29:45+00:00
When you run out of caffiene from your redbull, fuel up with a cup of hot coffee to make it through the day. This design is broken down into parts for smaller build area printers. Super glue can be used to secure all the parts together, but the pegs should snap fit together.
To use the DIY Coffee Machine, cut out the top of the 250mL can and poke a hole into the bottom of the can. Place a coffee filter into the top of the can. If the top ring does not hold the coffee filter, use elastic bands to secure the filter. Add in your favorite ground beans into the filter and pour hot water into the can.
This is a submission to the Upcycling Challenge hosted by MyMiniFactory and sponsered by Esso.
printed at 0,2 layer height without support.
| Date published | 19/02/2018 |
| Benoetigte Zeit | 540 - 600 Minuten |
| Menge an Filament | 60 |
| Dimensionen | 115,50x160x15 |
| Technologie | FDM |
| Schwierigkeitsgrad | Easy |
| Support Free | YES |