Crystal twist
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Crystal twist
This Lamp is a take on a modern design, with a twist... literally. the name Crystal twist comes from its two component the shade with a crystal like patern and the stem with the twist. I tried a lot of other designs before this and chose this one for its simplicity and for the strength of the Stem. features: The shade is easy to remove but can be glued on if necessary. the base design is hollow so wires can be run trough it. at last there is also an optional lid that can be printet and glued on the shade. Of course all the parts in this is compatible with the Original Elektromaker lamp Kit, in fact other 3d printable parts can be found on thier website.
Also something i am noticing now is how roselike the colors i chose are. strange.
The Stem should be no problem to print normal settings should be fine. though do be carefull since some of the outside edges do go up to 60 degrees. For the Shade is it only the thin walls that you should be carefull of, since their only 1 mm thicc.
Status | Rejected |