Desktop lamp
Desktop lamp
3D
Published 2020-05-06T13:49:30+00:00
Desktop, bedside lamp, for standard LED strip, fits two sections.
Prints in two parts (base+arm).
There is an option without hole for switch
0.2 layer height is good, but a change to 0.1 layer heigt for the top of the base will give a nicer curve transition.
Remember to add supports under the hole for the switch, if using simplify3D just manualy add support aroud the hole.
Support requierd for arm. (dosen't use that much)
A color change during the printing process gives a nice touch in my opinion.
Happy printing!
0.2 layer height is good, but a change to 0.1 layer heigt for the top of the base will give a nicer transition.
Remember to add supports under the hole for the switch, if using simplify3D just manualy add support aroud the hole.
Support requierd for arm. (dosen't use that much)
| Date published | 06/05/2020 |
| Dimensionen | 228mm height 100mm wide base |