Detailed caricature from an Austrian innkeeper, called Hubsi.
Detailed caricature from an Austrian innkeeper, called Hubsi.
3D
Published 2015-08-27T16:14:13+00:00
This is a very detailed caricature, from an Austrian innkeeper, called Hubsi. The figure is broken down into individual parts in order to produce as little as possible material support. It is 30 cm high. Approximately 400g including support material was the material requirement.The layer height was 0.15 mm, the wall thickness was 2mm and the infill was 10 percent. And the printing has time requires about 40 hours. For safety's sake, I have all the parts individually printed. For the glasses I have set the Layer height to 0.04 mm. I printed the figure because of the details in 30 cm. But I think to myself, 20 cm height would also be possible, without losing too much detail. Now I wish you a lot of fun, when reprinting the figure!
The figure is broken down into individual parts in order to produce as little as possible material support. It is 30 cm high. Approximately 400g including support material was the material requirement.The layer height was 0.15 mm, the wall thickness was 2mm and the infill was 10 percent. And the printing has time requires about 40 hours. For safety's sake, I have all the parts individually printed. For the glasses I have set the Layer height to 0.04 mm. I printed the figure because of the details in 30 cm. But I think to myself, 20 cm height would also be possible, without losing too much detail.
| Date published | 27/08/2015 |
| Menge an Filament | about 400 g |
| Dimensionen | 300 mm hight |
| Technologie | FDM |
| Schwierigkeitsgrad | Medium |