Direct drive for Ender 3 and CR10 fan duct
Direct drive for Ender 3 and CR10 fan duct
3D
Published 2020-03-11T10:45:06+00:00
Hello Makers,
Recently bought Micro Swiss direct drive extruder kit for Ender 3 and CR10.
Great gear, there are small issues with limiting printing area in Z but I will work on it soon.
Quality of print is greatly improved and I can finaly use Linear Advance!
My retraction is set to 0.7mm at the moment.
I used Noctua A4X10 fans for this project.
My Ender went from 55 dB to 33dB with SKR mini board used to silence steppers.
2 cooling fans are connected in series as they are 12V, my printer is powered by 24V.
I connected 2 5cm led strip in parallel then hot end fan is connected in series to it for the reason above.
There is bunch of M3 screws deifferent sizes and 1 nut needed, I bought them from known online shop in 300pcs kit.
All cables are soldered and packed under the cover between cooling fans.
If you neeed or wish to custom any of it, let me know file format you need please.
I used Fusion360 to make it.
Happy printing!
| Date published | 11/03/2020 |