Diving mask adapter for filter
Diving mask adapter for filter
Published 2020-04-02T02:57:18+00:00
__________________________________________________________
Note: 3D Prints are not safe for use in medical matters or other matters.
I take no responsibility for infections or injuries with the designs provided.
___________________________________________________________
This is a Remix.
I have also uploaded this to Thingiverse.
The parts are not tight and need to be sealed up properly.
This is an adapter for a diving mask to two filters of a ventilator.
There should be a better ventilation compared to a one filter design.
The filters are "intersurgical clear".
The 3 files provide the following models:
covid-19-filter-doppel-adapter-mit-winkel-42-5.stl:
The adapter has a gap at the connection to the mask but is free of problems.
covid-19-filter-doppel-adapter-mit-winkel-passgenau.stl :
The adapter fits tight on the mask but you will need to use " Keep Disconnected Faces " in Mesh Fixes in Cura because some walls may have issues.
covid-19-filter-doppel-adapter-ohne-winkel.stl :
This is a differend version where the pipes go to the right and the left.
It has the same problems as "adapter tight" and has a bigger gap at the mask so you need to change Cura.
Print Settings
Resolution:
0,2
Infill:
100
Date published | 02/04/2020 |
Support Free | YES |