Ear Comfort Face Mask Clip - 2 pieces, 3 variants
Ear Comfort Face Mask Clip - 2 pieces, 3 variants
3D
Published 2020-05-14T10:19:48+00:00
Support as well as feedback is always welcome ;)
This is a clip for loop based facemasks to reduce strain on your ears while wearing the mask for long time.
The loops are attached through inside latches, so theyre unlikely detach and you doent have to re-attach the clips every time you use the mask.
The length can be easily adjusted by clipping into different holes.
There are two versions: a standard version which is a bit tougher and an ECO version that prints faster with less material and has an area for your name integrated.
The Eco versions is also available in an XL length (but for most people the standard length should be fine)
Standard: max 35min for both pieces
ECO: max 20min for both pieces
!IMPORTANT!
Print the files with a .2mm layer height - otherwise details may be lost and the functionality of the parts may be impaired.
use 0.2 mm layer height
print without raft or brim using a slow speed for the first layer and heating the heatbed for more adhesion
if youre printing only one pait at a time you may consider setting a minimum layer time otherwise the hook may have difficulties getting printed properly
| Date published | 14/05/2020 |
| Benoetigte Zeit | 10 - 40 Minuten |
| Menge an Filament | 3 grams per pair |
| Dimensionen | 94mm x 65mm x 4.6mm per pair |
| Support Free | YES |