Echo Spot stand
Echo Spot stand
Published 2018-07-23T16:40:53+00:00
Adjustable desk stand for the Amazon Echo Spot. This stand offers a greater range of viewing angles than the official Echo Spot stand, and allows the Spot to be angled downward.
The screw plug can be used to adjust the tension on the arm - you may find that you need to adjust the scale of the screw plug by 1% in either direction in your slicer, depending on the filament you are using.
The stand is designed to use the following magnets:
https://amzn.to/2LncnGU but any magnets of equivalent size should be fine.
The magnets should be hot glued into the top of the stand (no need for any specific orientation), as should be the oval clip/bump
Ths stand is printed in 5 separate parts, without need for support. You can use 10% infill for the all of the components, apart from for the upright arm, where you should use at least 30% infill.
Date published | 23/07/2018 |
Benoetigte Zeit | 200 - Minuten |
Technologie | FDM |
Schwierigkeitsgrad | Easy |
Support Free | YES |