--- FaceShield V1.2 AND V1.3 Comfort --- (25min print time Vase mode with 1mm nozzle)
--- FaceShield V1.2 AND V1.3 Comfort --- (25min print time Vase mode with 1mm nozzle)
3D
Published 2020-03-24T22:52:31+00:00
Ready to use after printing.
UPDATE 2: For 1.3 Comfort we add stock (5,10,15) version for 1 and 0.4mm nozzle. Instruction added (Polish)
UPDATE: Added version 1.3 Comfort, that is more comfortable than 1'st edition in this link:
---> https://www.myminifactory.com/object/3d-print-115392
USE PET or PET-G ONLY
PLA IS NOT RECOMMENDED.
-1mm nozzle - extrusion set to 0.95 (same for Nozzle 0.4, should be fine)
Tips for 1mm nozzle - set temp 240-250C, or change it when printing, if you hear "cracks" from nozzle and see pause in prints - its too hot, set 5C less and try again.
-0.5-0.6mm Layer Height (depend of your printer and settings) (nozzle 0.4 set max 0.3LH)
-Vase mode (without TOP and BOTTOM) to print super clear without strings
-WITHOUT ANY SUPPORT <3
Should take 31 gram of PET-G and 25 min.
Version Comfort 28,53 gram and 23 min. :)
On my printer i can stock 8 of them at once, but recommended is printing one by one in vase mode
Version comfort cant be stocked one on one like version 1.2
TIPS from this file go for more filament, bindings covers and rubber ropes, you can help me with it.
| Date published | 24/03/2020 |
| Benoetigte Zeit | 15 - 30 Minuten |
| Menge an Filament | 31 grams |
| Dimensionen | 185,61 x 139,17 x 20,00 |
| Support Free | YES |
V1.1 235/70 PET Plast Spaw colling off 0.4 nozzle, layer width 0.5 1h30min