This is a homage to Scaramanga's gun from the classic 1974 film "The Man With The Golden Gun." It's is not movie accurate, but looks fantastic nonetheless.

When disassembled it comes in three innocuous pieces: a pen, cigarette lighter and cigarette case. But put them together and... Once printed: 1. To assemble the cigarette case, press-fit the bottom of the case into the main body and use a length of 3mm filament to attach the case lid to the body at the hinge. 2. To assemble the trigger, push a short piece of 3mm filemant into the trigger and store in your cigarette case. 2. To assemble the cigarette lighter, slide the breech into the main body of the lighter. The breech has one end that has a thread - this end needs to face outward. 3. To assemble the pen, push the pen clip into the pen top, from the top. Screw the cap (the one with male thread) into the pen top. Screw the other cap (the one with female thread) into the other end of the pen and push the two ends of the pen together. They're provided in two pieces so you can fine-adjust the position of the pen clip to act as your sight. Once you've got the three pieces fully assembled, follow these steps to turn them into your golden gun: 1. Unscrew both caps from the pen. 2. Screw the pen into the lighter breech. 3. Slide the breech out. 4. Open the lid of the cigarette case, take out the trigger and slide the cigarette case catches into the slots on the lighter and breech. Push the breech back toward the lighter to secure the case. 5. Push the trigger into the hole in the lid of the cigarette case.

Now it's time to take down Mr. Bond. Please note that the breech may be a little tight until it's had time to wear in. Slide it in and out a few times and it will become easier to move, but don't force it initially as it can become stuck. Please note that this is a replica only (not even that - it's an impression of a replica). It is not capable of firing nor can it be made or modified to fire.