Halo Spiker / Spike Rifle
Halo Spiker / Spike Rifle
3D
Published 2015-02-13T18:23:51+00:00
The Type-25 Carbine is a fully-automatic, magazine-fed rail-type weapon. As its metal projectiles are pulled between the rails they are superheated and elongated into the spikes that are its namesake. Two large blades made of tungsten carbide, an extremely strong and durable material, are mounted under the barrel of the weapon, increasing its effectiveness in close-quarters. The Spiker's ammunition is fed into the weapon via a small drum magazine with a 40-round capacity. The drum magazine is located on the underside of the weapon, behind the blades and in front of the trigger.
The Type-25 Carbine, also known as the Spiker or Spike Rifle, is a Jiralhanae firearm used commonly during the Human-Covenant war.
This is a long print but it is well worth it! I managed to print it in 5 goes. Each printed at 0.2mm layer height and 8% infill. The main gun section is all slotted together without glue. I used a rubber mallet to help get some of the pieces together but no cutting or gluing was necessary. This section took 423 grams of filament and 1997 minutes The back half of the blades and all of the smaller pieces took 437 minutes and 50grams. Each blade took 448 minutes and 54 grams. And the final pieces took 313 minutes and 67 grams.
| Date published | 13/02/2015 |
| Benoetigte Zeit | 3600 - 3700 Minuten |
| Menge an Filament | 648g |
| Schwierigkeitsgrad | Easy |