Holder for "DOT-it" battery lights
Holder for "DOT-it" battery lights
3D
Published 2019-10-02T16:10:11+00:00
It is a simple C-clip mechanism that holds battery powered round lights, like the "DOT-it" (no ad, just had this version lying around and needed a new light for the garage...) in place, so that you don't have to glue them somewhere and you can replace the battery without having to rip off any annoying glue... It shoud be good for any round battery spotlights with diameter around 67mm and thickness about 18mm, excluding the glass. But you can also scale it if something doesn't quite fit.
recommended material: PLA
support? Might be helpful if you want a very clean print, but not necessary
bed adhesion: some magic goo or pritt glue pen can help to prevent the C-shaped section to warp and destroy the print.
Nozzle: 0.4mm; Layer height: 0.25mm or lower; wall thickness: 1.2 mm or higher; top/bottom thickness: around 1mm; printing speed on CR10: 35 for walls and 50 for the rest, first layer 20 or lower; infill: grid 15%
Be very careful when mounting the holder to a wall or furniture, if you don't feel comfortable handling a drill hammer, ask an adult for support ;)
Because of the chamfer pls. use screws with chamfered head.
| Date published | 02/10/2019 |
| Menge an Filament | depends on infill settings |
| Dimensionen | diameter:78mm X 29.5mm |
| Support Free | YES |
