K-Cup Coffee Grounds Extractor Mini - Fits "Regular" Mouth Mason Jars
K-Cup Coffee Grounds Extractor Mini - Fits "Regular" Mouth Mason Jars
3D
Published 2020-03-23T17:16:53+00:00 • Remixed from K-Cup Coffee Grounds Extractor
TL;DR: This needs to be dipped in hot water to fit inside the lid ring. Check the measurements before printing.
I only had "regular" mouth mason jars. I shrunk down the outer rim to fit inside the lid, but didnt realize until after I printed that the wall is still just to wide to fit through the mason jar ring.
I dipped the whole thing in hot water and then it fit through the ring no problem. (My first try was to crush the edges of the ring slightly, but that didnt work.)
Thsi is my first print file that I have modifed. Im still not greate at modeling otherwise id upload a fixed file. If i were to do it again, Id make the outerwall 56.2mm in diameter without changing the size of the lip. I included the sketchup file if that is helpful to anyone. Additinally, I may have even tweaked the scale slightly in cura before printing, so check the measurements be for printing.
Printed with support, using cura normal or low quality profile.
Took about 3 hrs on my Wanhao i3 Mini
| Date published | 23/03/2020 |
| Benoetigte Zeit | 3 - Minuten |
