MinimX
MinimX
Published 2017-03-16T10:16:37+00:00
'X' style quadcopter frame with possibility for attachments. Made to print on small printers.
This is part of my journey into both 3D printing and 3D flying. Fun.
Designed primarily to used as a platform for robotics (computer controller flight), but aewsome fun to fly RC, it is small enough that mis-steps are not catastrophic. All parts but the electronics are printable and reprintable (I must have printed at least 9 arms!!!)
There are a couple of different arm styles; you only need to print one set of four... there are 2 different goPro style mounts; these are accessories only. The feet are not necessary either.
I used 2" machine screws to assemble and have legs.
Complete (with electronics) kit available here http://bit.ly/kendoTindie
Take a look at this project on hackaday.io http://bit.ly/MinimX
Check out my other projects on hackaday.io http://bit.ly/kendoHIO
I printed this in Filaments.ca PLA 25% infill, no supports needed, 0.20 layer height
Date published | 16/03/2017 |