Multipass Badge Holder
Multipass Badge Holder
Published 2018-03-05T10:53:26+00:00
This is the Multipass from the movie 5th Element. It's been scaled down a bit and modified to hold a standard Badge/ID. The badge slides in and lcoks into place so it cannot fallout of hte holder. Printed in Pure Silver PLA. The Yeelow putton was printed in True Yellow PETG. Painted with White and Red Acrylic paint and copper enamel paint.
The hole in the upper right is for a chain like they used in the movie. The sot in the top and bottom have been added to allow you to attach it to your lanyard of badge clip.
You can print the body and lens seprately as i did here or you can print it all in one and paint everything.
UPDATE: Added another file. This is a Mirrored version with a plain face. Thus allowing you to glue it to the back side of the main print giving you a slot for a second badge.
Print as is. Recommend printing with 0.1mm layer height. Supports are required. Reccomend setting the supports so they do not support bridgeing. Otherwise supports may be difficult to remove without damaging the print.
Date published | 05/03/2018 |
Benoetigte Zeit | 180 - 230 Minuten |
Menge an Filament | 21g |
Dimensionen | 118x80x5 |
Technologie | FDM |
Schwierigkeitsgrad | Easy |