Nintendo Switch Alternate Dock
Nintendo Switch Alternate Dock
3D
Published 2017-03-20T17:42:42+00:00
Check out other successful prints of this design!
http://www.thingiverse.com/thing:2186911/#made
My Submission for the Nintendo Switch challenge.
WARNING: I am not responsible if you destroy your dock. For this print to be useful the original dock has to be dismantled. This will most likely void any warranty you may have on it. Please be sure you know what you are doing before attempting this project.
This is my design for an alternate Nintendo Switch dock. It uses all the parts from the original dock. I was very disappointed with the one provided by Nintendo.
Note: I still have to figure a good way to integrate the LED light.
Instructions: Print all parts and assemble. Just need 8 machine screws and all the parts from the original Switch dock.
4 - 12mm (Length) x 2.75mm (Thread Diameter)
2 - 12mm (Length) x 2.1mm (Thread Diameter)
2 - 6mm (Length) x 2.1mm (Thread Diameter)
Piece of 1mm thick felt
| Date published | 20/03/2017 |
| Technologie | FDM |
| Schwierigkeitsgrad | Medium |
| Support Free | YES |
White PLA, Blue Glow-in-the Dark PLA, and clear NinjaFlex for the tubes.