OP-1 BestCase // Waveform
$9.99 OP-1 BestCase // Waveform
Published 2020-04-24T11:03:38+00:00
Protect your OP-1 in the coolest way possible with this minimal, multicolored, deck protector! The OP-1 BestCase is both a cover and a stand that tilts the OP-1 up to take advantage of the same ergonomic benefits that computer keyboards have been rocking since the 80's.
The Waveform model uses single extruder multipass printing for up to 5 colors on the first layers of the print! You can learn more about the technique here. Of course, if you have a multimaterial printer, that works too!
The model includes round tabs at each corner to improve build plate adhesion. They can be ripped off afterward, or cleanly removed with a X-acto knife.
As you're likely aware, PLA is not sun-friendly, so avoid exposing a PLA case to warm environments to prevent warping. If you want extra security, I recommend silicone bands like these (also on eBay) or these.
*MULTIPASS SETTINGS*
A_white : 0.4mm wide, .15mm layer height
B_green, C_blue, D_red, E_case : 0.4mm wide, .15mm layer height, at least 0.6mm vertical z-hop during travel
*MULTIPASS SETTINGS*
A_white : 0.4mm wide, .15mm layer height
B_green, C_blue, D_red, E_case : 0.4mm wide, .15mm layer height, at least 0.6mm vertical z-hop during travel
Rotate 45 degrees on the Z axis to fit on a 300x300mm bed.
Date published | 24/04/2020 |
Price | $9.99 |
Support Free | YES |