Phone Stand with Charger Cutout
Phone Stand with Charger Cutout
3D
Published 2020-04-20T20:50:56+00:00
Perfect for all the video chatting we're doing. The phone stand was designed to look as if it was a single bent piece of material. Although the angle does not adjust, its been optimized for viewing notifications and for unlocking with Face ID. The thin backing allows users to use continue using their devices unobstructed. As a bonus, I printed it with wood filament which mimics a natural veritcal wood grain almost like bamboo. Hope you enjoy!!!
This phone stand sports:
- 65 degree angle
- cut out for a charger
- a slim profile and backing
Note: the provided print time is with my settings and nozzle size, may vary from printer to printer.
Raft on (just because it doesn't have much surface area on its side)
No supports needed
0.8 mm nozzle
PLA wood filament 1.75mm
Print speed 60mm/s
Nozzle 200 C
Bed 60 C
| Date published | 20/04/2020 |
| Benoetigte Zeit | 105 - Minuten |
| Menge an Filament | 74 g (with raft) |
| Dimensionen | 109mm x 58mm x 71mm |
| Support Free | YES |
