Polygonal cat ears for V-Moda headphones
Polygonal cat ears for V-Moda headphones
Published 2020-11-10T10:20:14+00:00
IF YOU LIKE THIS MODEL, PLEASE CONSIDER DONATING TO MY SURGERY FUND
Low-poly looking cat ears with a base that allows it to be slid over the back of the headband of a pair of V-Moda headphones. Pictured here on my recently restored old pair of V-Moda Crossfade LPs (with a fresh coat of Flex Seal to fix some rotted vinyl).This will likely work on some other headphones too, but I made it for my V-Ms so that's all I measured it for!
These are made to be 'removable' in that you slide them off and on and it uses tension to stay in place, but I advise sanding the hard edges to reduce it digging too hard into the headband.
It's okay for there to be a slight gap between the headband and the bottom of the base as I wanted to keep allowance for headband deformations when worn, stored, resized, etc...
Another thing I found handy was gluing a bit of foam between the two if you find the corners of the 'clips' dig into your head any/too much.
layer_height_0 = 0.2
extruder_temperature = 200
material = PLA
material_bed_temperature = 95
support_enable = False
adhesion_type = brim
infill_pattern = gyroid
infill_sparse_density = 20
retraction_amount = 2
Date published | 10/11/2020 |
Support Free | YES |