Printable "Lack" Table
Printable "Lack" Table
Published 2018-03-12T14:40:36+00:00
This is a table I designed to be printable using about 1kg of filament. It is designed around the dimensions of the popular ikea lack table, but isn't exactly the same. I designed it with a 12mm recess for the top to be made out of left over laminate flooring that I had laying around. You can use whatever you want for the top though.
I printed it with PLA and it's been fantastic so far. It's even sturdy enough that I trusted it to hold my new Prusa MK2S (11kg/ ~24lbs) for a few days while I rearranged my office. I even ran some prints with the MK2S on the table for a while after I finished assembling it. You can obviously print it in whatever filament you want though.
Printer: Tronxy X3S 0.4mm nozzle
Rafts: Doesn't Matter
Supports: No
Resolution: 0.2mm
Infill: 3%
Shells/Perimeters: 4
Notes:
These are the setting I used to print it. It's holding up very well and wobbles very little. I did not add any glue to the joints, but you definitely can to stiffen it up even more. Part orientation on the build plate is important, so take care in placing it on your build plate if you decide to print this.
Date published | 12/03/2018 |
Technologie | FDM |
Schwierigkeitsgrad | Easy |