QueerAsF*ck Necklace
QueerAsF*ck Necklace
3D
Published 2020-09-06T21:20:22+00:00
Who doesn't want to shout about their queerness sometimes??
A very early design of mine, born out of the design to be Loud and Proud. Probably not safe for sensitive viewers, as it does contain a rather significant swear word. Alas, some pride cannot be contained!
Layer Height: .2mm
Supports: Yes, depending on orientation, see below
Perimeters: 2
Infill: 20%
This model definitely prints best flat on the print bed, however, if you are looking to get an interesting gradient with a transition filament, you may find you need to change the orientation for the gradient to show on the front of the necklace. I successfully printed it at pretty much a 45 degree angle to the bed with lots of supports; the results were beautiful but there was a lot of clean up! Jump rings and a chain can be attached to the circles at the end to make it a proper necklace! I also covered mine in a coat of clear resin to make it shiny and glossy.
| Date published | 06/09/2020 |
| Menge an Filament | 13g |
| Dimensionen | 122mm x 22mm x 10mm |