Small, simple flowerpot with drainage holes
Small, simple flowerpot with drainage holes
3D
Published 2018-04-03T09:41:49+00:00
A small flowerpot with drainage holes. I also added a second version that works well for larger plants, and I've added versions with a lower polycount as well.
All files should be quite easy to print, except for files Flowerpot_inside_high and Flowerpot_inside_low. I would recommend to print those upside-down. It will make printing those feet a lot easier, but needs a lot more support material.
I have not printed these at a large scale yet so if you do, please tell me how they work.
The tolerances on the seperated pots are 0.3mm.
I have also added a version of the seperated pot, called Flowerpot_small. It is way easier to print and can also be printed at a way smaller scale. I have successfully printed one that is about one centimeter in diameter with my FDM-printer. With a SLA-printer you could obviously go even smaller. At this scale, howewer, it is hard to find a plant that can grow in it.
The tolerances are still 0.3mm by default so when printing extremely small pots you have to be aware of the tolerances. If the pot doesn't fit inside the cup, try scaling the cup up by a small amount.
Try printing files Flowerpot_inside_high and Flowerpot_inside_low upside-down. They will use more support material that way, but those feet should be way easier to print. All other files should be easily printable without supports.
About the files:
Flowerpot_high and Flowerpot_low are high- and lowpoly versions of the default pot
Flowerpot_inside and Flowerpot_outside are the default pot, but divided into two parts. These also have high- and lowpoly versions.
Flowerpot_large is a version that should be printed larger, since the water catcher is so small. It can of course still be printed at a small scale, if you want so.
Flowerpot_small_cup and Flowerpot_small_pot are the newest wersion, and can be printed way smaller. The pot part is also way easier to print than in the original vesion.
| Date published | 03/04/2018 |
| Dimensionen | Pretty much all the pots have to be rescaled before printing. |