Snowman with Hat
Snowman with Hat
Published 2017-11-24T09:02:38+00:00
Snowman bowl designed for the Tinkercad Christmas competition. Multiple files are attatched to give you printing options.
This object was made in Tinkercad. https://www.tinkercad.com/things/h2jefEJMFVg
Vase mode is not recommeded for the head portion. The "coal" protrusions are a possible fail point. I did manage it, but had to glue the bottom section of the print back on.
Vase mode is possible for the hat using the files labeled 2 piece hat. Slide the brim down over the hat and glue. In my case, there is a small gap between the brim and body of the hat. Also, the body of the hat protrudes into the bowl a few mm's. This is helping to keep the hat in place.
I printed the head with no support, the lower portion was a bit rough but it worked fine. I'm using a Monoprice Select Mini V2.
Date published | 24/11/2017 |
Dimensionen | 110 x 110 x 150 tall. |
Support Free | YES |