Soda to Bottle Neck (Vase-mode able)
Soda to Bottle Neck (Vase-mode able)
3D
Published 2019-11-18T00:15:11+00:00
If you want a cool accessory, or an awesome party bringer, then this object is for you.
This object is a 3D-printable bottle neck device that makes just about any boring soda can into a cool one.
Why is it cool?
Well you see. The human race has elbows that like to knock things over, and when you combine that with soda, it turns into a hazardous mess that no one likes to clean up.
When soda (with the neck in place) is bumped, it will give the user more time to react and pick the can up before all contents are out on the floor.
One more bonus! It prints in vase mode (spiralize outer contour)! If you don't have an hour, then you don't have to wait one for it to print!
Make sure it is set to vase-mode being Spiralize Outer Contour on Cura.
Also make sure that the model is oriented the right way on the slicer (Wide at the bottom)
Infill: 0%
Layer Height: anywhere from .1 mm to .25 mm
Bed adhesion: Brim (unless you trust your printer with skirt)
Anything else is up to you :)
| Date published | 18/11/2019 |
| Support Free | YES |
