Symmetrical Tealight Holder
Symmetrical Tealight Holder
3D
Published 2020-06-05T10:42:38+00:00
DISCLAIMER this tea light is meant to be used with Flameless LED Candles and it should NOT be used with real candles unless you are using heat resistant filament or resin that is fit for that purpose.
One of several tealights I designed while I was at College and then worked on bit more as I do like candles and experimenting with new materials which is why I even casted them in concrete and resin. I aimed to make them simple and minimalist to fit in a modern environment why being practical having grooves for wax overspill and hole on the bottom for easy extraction of tealights themselves.
They can be used without "base pads" but it depends on where you want to put them and what will you print it in. In general, I use them without it and only make pads from if I'm giving them to someone either laser cut them or cut them with a scalpel from cork or print them from TPU.
Tealight holders in pictures are print out at 0.3mm layer height with 0.6mm nozzle but if I would be printing it for someone else I would go lower to 0.1 or 0.15mm layer height. This model does not require supports if your printer is relatively well calibrated but even if you want to print with supports its only like 1g or filament extra.
| Date published | 05/06/2020 |
| Menge an Filament | 15g |
| Dimensionen | 72mm x 72mm x 21mm |
| Support Free | YES |