Tacblade Utility Knife
Tacblade Utility Knife
3D
Published 2017-09-12T14:05:42+00:00
This is my folding knife design for disposable Stanley style blades.
Its a hybrid between a friction folder and a flipper.
Designed for the UK so no lock, but is very stable in the open or closed position.
100% printable, the bolt best at 0.12mm layer height and all other parts at 0.2mm layer height.
Its been designed to print so easily, no support, no rafts, no brims. Very lightweight but also rugged design.
Disclaimer:
Tacblades will not be liable for any damage or injury as a result from use or misuse of the knife printed from these files. It is the responsibility of the owner to handle the knife with care and its intended use as a tool.
It is the responsibility of the owner to ascertain and obey all applicable local, state, federal and international laws regarding to the printing, possession, and/or use, of products made from these files.
Print at 20% infill 0.2 layer height no support, no brim
The bolt is best printed at 100% infill
The screw and screw hole can be tight at first,
just screw in a few times, tighter each time to clear the threads.
The tolerances are very tight so take care on cleanup and sanding.
square all edges and inner holes for piviot, any elephants foot from first layer should be removed.
You can lubricate the pivot with oil if you want.
| Date published | 12/09/2017 |
| Benoetigte Zeit | 3 - 5 Minuten |
| Menge an Filament | 27g |
| Dimensionen | 150x100x15 |
| Technologie | FDM |
| Schwierigkeitsgrad | Very Easy |
| Support Free | YES |